• Turns Unit : 0.1
• Max. Turns : 99999.9
• Start slow : Set acceleration Rate when starts.
• End slow : Set deceleration rate when stops.
• Compensation : Compensate the error turns to fit to setting turns
  in a initial testment.
• Couter : count winding jobs.
• Initialization : Initailize couter-memory.

• Power : 100V ± 10%
• Step : 10 steps
• Turns : Max. 99999.9
• Speed : 5,000 RPM

• Motor : DC90, 90W
• Belt : 5M, 300M/M
• Bearing : front 6202, rear 6201
• Dimension : 200(W) x 295(D) x 240(H)

• Precise guide feeding with CNC type controller.
• Treverse Setting
  - NO : Pause after one step and continue next step by pushing the start switch.
  - LINK : Same as NO. but start next step at existing position.
  - AUTO : Pause at the starting position after one step.
  - JUMP : Run automatically to the last step.

• Brake Release Setting
  - TIME : auto releasing after 0.4 seconds
  - HOLD : releasing by pushing stop switch
  
• Start slow : Set acceleration rate when starts.
• End slow : Set deceleration rate when stops.
• Motor Start Angle Setting
  - NO : Existing position
  - 000 : Top position
  - 180 : Bottom posiiton
  
• Motor Rotation Direction Setting
  - FWD : clockwise
  - REV : counter-clockwise

• R.P.M. Setting
  - Speed Low R.P.M.
  - Speed Max R.P.M.
  - ACCEL : Acceleration rate setting by 0.01 sec (10 R.P.M.)
  
• Calibration : Compensate the error turns to fit to setting turns in a initial testment.
• Couter : count winding job
  

• Power : 100V ± 10%
• Steps : 25 steps
• Turns : Max. 99999.9
• Speed : 5,000 RPM
• Motor : 220V / 50Hz, 120W

• Belt : 5M, 300M/M
• Bearing : front 6202, rear 6201
• Dimension : 300(W) x 400(D) x 400(H)
• Pitch Unit : 0.001mm
• Bobbin Unit : 0.01mm

Copyright 1998 D.A.S.H. Systems. All right resered.
#503, Gayang Factory Bldg., 5th Block, Gayang-dong, Gangseo-gu, Seoul, Korea [157-200]
Phone: (Rep.) 82-2-2659-9011
Fax: 82-2-2659-9015